Missing 100mm on Z height on Vcore 4 500
Hopefully this is an easy one but I just realized when I try to go the max height on my Vcore 4 500, I can only hit 415mm. I did check my configurator and I chose the Vcore 4 500 hybrid. Not sure where to else to look in the printer.cfg or RATOS.cfg
Thanks in advance!
3 Replies
You tried to go to 515, out of range. Try moving in smaller increments
Solution
Or in console do something like
g0 x50 y50 z500<sigh> That was such a simple fix I don't know why I didn't attempt that lol I guess I was too tired last night trying to figure out my banding issue on my prints that I ignored the obvious thing to try. On to my next issue 🙂
Thank you! @TheTik