Swhy are you subscribed to the click event
Ethe last button is there only to test if the navigatecommand in my datacontext (navigationbarviewmodel) work well
Show is it supposed to do that
Sjust put a breakpoint in your command.Execute
Ei've already done that and the 3 button with the command do not execute the method
Ewas just to see if the navigation was correct, if my page change well
Sare you sure your datacontext is set properly
Ei think but not 100% sure
Smake sure
E
Ewith this breakpoint i can see that my datacontext contain the good information
Swhen you click this button does the navigation work?
Eyes
Eand when i click on the button which is sub to the command it do not execute the command
Sare you 100% sure the breakpoint in the command doesnt get hit?
Eyes cause the beak point is hit when i click on the button_click and it is'nt when i click on the command button
Snot this breakpoint
Sdid you put a break point in the command's Execute method?
E
Eand if i click on the command button the second breakpoint do not get triggered
Sput it at the start of the method
Swait the breakpoint is hit in your screenshot lmao
Enothing change it does the same
Sits yellow
Eyeah like i said hit when i use click button and not when i use command button
Soh thats from the event
Eyup
Ei just wanted to be sure that the "process" was functional that's why i setup this click event
Sno idea then sorry
Eok no problem
AWas this issue resolved? If so, run
/close- otherwise I will mark this as stale and this post will be archived until there is new activity.
E.
