Ray Kholodovsky - Camera in 3D view: Orthograp...
Camera in 3D view:
Orthographic
Top Down
How come when I go to PCB and back to 3D my camera angle / view is not the way that it was before???
Actually I think it's when I save the file and the 3D view refreshes itself that it goes off on the weird angle.
It could be from either action, at different times.
3 Replies
when I press Top Down, I expect the bullet point mark to stay on Top Down, respecting the position. We discussed this a while ago. It's still not doing that.
ok so the moment I zoom out on 3D then switch tabs to PCB and back to 3D that is enough to cause it to break and end up sideways when I go back to 3D