RRC
Rat Rig Community [Unofficial]•2y ago
quaint-moccasin

Z stepper identification

Simple question, which is the LEFT Z stepper and which is the RIGHT Z stepper? I can't find anything that says the orientation of the viewer (person) that will tell me which is which. Are they left and right as if I'm standing in front of the printer and I'm facing the front of the printer? Or is it the left and right side of the printer as if I'm standing behind the printer facing the back of the printer?
2 Replies
8Complex
8Complex•2y ago
No description
quaint-moccasin
quaint-moccasin•2y ago
perfect, thank you
Want results from more Discord servers?
Add your server
More Posts
Brim is not consistentHi, since ASA needs more adhesion, I print it with 10mm brim. The problem is that about half of it l(SOLVED)Rasp Pi 3b+ not detecting ratos.local host ???I loaded everything on Pi's card and did the first config and detected ratos.local fine...now I finiManta M8P and 3 pin fansHi everyone. I'm new to klipper (coming from reprap). I'm struggling trying to install and configureWhy is my filament marshmallowing to 1.6mm diameter?This is Amazon Basic PLA that I am feeding manually through my VC3 control panel interface. I am loaZ offset does not work consistently..I have a vcore 3.1 500. I am using the superpinda... I set the z offset using CALIBRATE. It worksRATOS + Timelapse + DSLR controlHas anyone used a DSLR with RATOS? Do I need to install Gphoto2 on the Rasp Pi to control the camera