![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
(SOLVED) SKR 2 Fan2 incorrect socket?
Hiya all, building my v-Minion from a full kit via Fabreeko.
Ran across an odd issue. My SKR 2 board Fan2 socket (which is used for the electronics enclosure fan) seems to be switched around.
Board pin out says 1st pin is VBB (+) and 2nd is PB5 (-). Wiring diagram shows fan should be plugged in with pin 1 - red wire, pin 2 - black wire.
However the socket seems to be backwards. If I plug in the fan, pin 1 will be black, pin 2 will be red. Fan0 and Fan 1 sockets are correctly oriented.
Should I switch the pins in the connector around? I just want to be sure they didn’t switch the pins in the socket around too.
(No I will not power it on with the fan header plugged in until I’m absolutely certain it’s safe. It was plugged in just for the picture to show what’s going on.)
Ran across an odd issue. My SKR 2 board Fan2 socket (which is used for the electronics enclosure fan) seems to be switched around.
Board pin out says 1st pin is VBB (+) and 2nd is PB5 (-). Wiring diagram shows fan should be plugged in with pin 1 - red wire, pin 2 - black wire.
However the socket seems to be backwards. If I plug in the fan, pin 1 will be black, pin 2 will be red. Fan0 and Fan 1 sockets are correctly oriented.
Should I switch the pins in the connector around? I just want to be sure they didn’t switch the pins in the socket around too.
(No I will not power it on with the fan header plugged in until I’m absolutely certain it’s safe. It was plugged in just for the picture to show what’s going on.)
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}