RRC
Rat Rig Community [Unofficial]•2y ago
metropolitan-bronze

Did a full reinstall of Klipper and Board firmware

Followed the directions like last time, updated the firmware on the board and installed the latest Alpha. However, once I get to Mainsail I have this message now '/home/pi/printer_data/config/config/boards/btt-skr-pro-12/config.cfg' does not exist Anyone come across this or will I just need to do another fresh install?
2 Replies
blacksmithforlife
blacksmithforlife•2y ago
You will not be able to reuse your printer.cfg. there is a new template and you will have to copy the values where they apply over instead
metropolitan-bronze
metropolitan-bronze•2y ago
Ahh, okay, thank you!
Want results from more Discord servers?
Add your server
More Posts
Hallo zusammen , habe heute ein Update gemacht. Jetzt bekomme ich keine Verbindung zu Klipper mehr .Extruder not Working During PrintHaving issues with my extruding not actually putting out filament. As in it wont spin at all during Corner dip. Bed level with PAM. Uneven first layer. i.e. perfect layer one side, opposite too closeI have a problem that when laying the first layer, it does not seem like PAM does anything or not enwarped holesextra holesIm printing the parts in abs for a enclosed ratrig printer, and some parts have these warped holes aOverhanging issuesHi, I recently changed the nozzle to a Bondtech CHT .4mm. In general the print quality is fine afterBLTouch failed to verify sensor stateBekomme gerade aus heiterem Himmel diesen Fehler "BLTouch failed to verify sensor state" web ich ein