Ugly ASA print outer layer
Having problem getting a consistent outer layer with ASA.
Have played with EM 91-95 and PA 28-45
Temps are 255 nozzle and 105bed chamber in 70-75
Cpap fan 16% normal 20% bridges.
Not sure what to try next as it seems to get better with abit more EM started at 91 but after 94 its getting worse again.
6 Replies
rare-sapphire•2y ago
rare-sapphire•2y ago
old-apricot•2y ago
Your CPAP sucks cold air from outside the chamber?
From the Look I would say more Fan, but you want the hot chamber air blowing onto the part
rare-sapphire•2y ago
Cpap sucking from inside chamber under bed.
rare-sapphire•2y ago
old-apricot•2y ago
Then try more fan and see If it gets better