![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
(slight) resistance on one end of linear rails: de-racking vs using y-gantry to align rails?
I'm noticing a small amount of resistance on my Y rails towards the back of my v-core 3.1, which isn't there on the front half. I read on Ellis' guide that this could be the cause of some VFAs I'm noticing on the prints. Elli's guide recommends de-racking, but I'm not entirely sure how to go about it with the v-core, and it occurred to me that I can probably just loosen the linear rails on the y axis slightly, move the gantry back and forth so it sets in the right position and then tighten it them again. Would this be a terrible idea that will cause me other problems?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}