Firmware not flashing
I am very new to this so I appolgize if I do not explain my problem well.
I have a Pi connected to my network
I have downloaded the firmware-btt-octopus-11.bin file then changed the name to firmware.bin
I installed the file on a SD card and restart the printer.
The firmware.bin file on the SD card does not change to .CUR
I get a Kippy error MCU unable to communicate
I have the jumper removed and all wires unplugged from the board.
What am I doing wrong or what should step should I take to fix this?
2 Replies
How did you format the SD card you used to flash the firmware? You can't move on until that completes
sensitive-blue•2y ago
Yes I have been formating the SD card.
I tried a smaller SD card and now the firmware is correct.
but I am now getting an ERRORMCU 'mcu' shutdown: ADC out of range
This generally occurs when a heater temperature exceeds
OK I'm making progress.... I have a connector in the wrong location.