Topics

Rat Rig Community [Unofficial]•16mo ago

fascinating-indigo

cant connect to klipper

Hello Everyone. First of all. My printer has been just fine with printing and everything. Just noticed a lot of updates. So started updating and now I can't connect to Klipper. Can anyone help me.

8 Replies

fascinating-indigo•16mo ago

only one left to update is System and that one is showing an error. Do I need to reflash and reset everything.

blacksmithforlife•16mo ago

What version were you on and what version did you update to?

fascinating-indigo•16mo ago

No description

blacksmithforlife•16mo ago

Did you upgrade from Rat-OS 1.2x?

fascinating-indigo•16mo ago

Honestly. I wasn't paying attention to what I came from

blacksmithforlife•16mo ago

Well you can't upgrade from 1.2x version to 2.x. that requires a reflash of the SD card and using the new templates

fascinating-indigo•16mo ago

OK. So do i need to reflash everything then?

blacksmithforlife•16mo ago

Given you don't know what version you were on and it doesn't seem to be working, I personally would reflash. Use the values from your printer.cfg to fill in the new printer.cfg. don't just copy and paste the only printer.cfg as that won't work

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

More Posts

RatOS 2.0 Error Notifications (Solution)Fresh install with RatOS 2 and finding that every restart 2 error notifications show up? This has be Z_TILT_ADJUST - Impossible to complete.Hello. since 5 hours I can't handle both with Z_TILT_ADJUST I checked everything I know, even change Infill not connecting with outer wallI had this problem before on my ender 3 and I fixed it with a setting in prusaslicer, but I can't re Rescue print after Power outageHey, so around 40h into a 60h print job we had a power outage. I plan to resume printing but am unsu wavy, artifact and layer shiftHello, since I don't have as much experience with setting up the firmware of the 3D printer I figure Drucker nicht mehr erreichbar, druckt aber weiterHallo zusammen, ich hab heute den Drucker in einen Nebenraum verbannt und seitdem bricht die Verbin RatOS not connecting to work networkHi all I've recently rented an office with shared wifi and I added the new IP and password to the .c Lautstärke beim verfahren von YIch habe das Problem das mein Drucker beim verfahren von Y eine recht hohe lautstärke hat . Das hört Rapido UHF can 't reach more than 226 °CAnother day another problem I have a Rapido Plus UHF with a heater up to 350°C, connected to the EBB G28 Home all behaviorI have sensorless homing setup for X and Y which seem to work independently if I home X and home Y.