Will have to do a video of this one...will make a lot more sense... VERY odd moves going on.
The order and movements doing the very first 'home all after getting everything up and running under RatOS v2. were REALLY weird.
1- hit 'home all' in mainsail (trigger finger on the EMO just in case...)
2- Z drops 10mm , X slowly heads left, hits the x stop... backs off and retouches.... then Z drops another 5 or so mm and x zips quickly back to center of bed where Z drops again
3-gantry heads for Y max - taps the end stop, backs off then slowly taps again, then before zipping back to bed center yet another bed drop another 5 or so mm
4- carriage hits x250/y250 (bed center) then dances once or twice between nozzle being centered and z probe being centered, end with probes at 250,250
5- bed now has to rise nearly 50-80mm to hit the z-probe. where that all ends normally.
In short form..it seems like at the start of every 'travel' , the bed would drop as if moving out of the way for homing function.
It did it heading for X stop, then again heading back to bed center before heading for the Y stop, after the Y stop before going back to bed center for the final Z probing
very wierd.
Biggest Q though.... why did the 'home all' routine change? old 'home all' use to just got to X0 end stop, then the gantry would go to Y max end stop then diagonally right to bed center for the z-probe.
...any way to return to the old x -> y -> center -> z probe routine?