Will the Galatea Hotswap pcb have any clearance issues with the OG r2 f1 8x?
not sure if the multi layout support of the hotswap sockets will cause any fitment or clearance issues (sides and bottom)
12 Replies
If you are asking about the compatibility of F1-8x products and Galatea Hot swap products, you can use them without any problems.
I'm not sure if the Galatea hotswap PCB will be released from Geonworks at this point.
If you are talking about this one https://rndkbd.com/products/galatea-tkl-hotswap-pcb ,
I would recommend removing the JST connector.
What’s the cleanest way to break off the jst connector?
desolder
it would be difficult to heat up the pads to remove the jst connect because the two legs are underneath the connector, no?
This is a photo that Lin took.
Remember that you have to take the risk of breaking the PCB.
Pilers
Why do you recommend removing the jst connector if there is a risk of breaking the pcb
If I remember correctly, the JST connector will bottom out when typing
I would buy an Apollo PCB if I can
Okay