![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
500mm Bed Mesh & Z-Offset
I’ve ran a few meshes prior to a one hour heat soak and when I’d home and 0 the toolhead the paper test would give me the correct amount of friction.
I just ran my last bed mesh calibrate around an hour of the bed sitting at 100c, however now when I 0 out the toolhead there’s 0 friction.
Is it okay to run like this or should I do the paper test now and manually change my Z-Offset? The upcoming print will be about 30 hours.
Thanks!
Initial 0.5XXmm deviation was from a cold run and the latest is from it heat soaking for about an hour or so.
I just ran my last bed mesh calibrate around an hour of the bed sitting at 100c, however now when I 0 out the toolhead there’s 0 friction.
Is it okay to run like this or should I do the paper test now and manually change my Z-Offset? The upcoming print will be about 30 hours.
Thanks!
Initial 0.5XXmm deviation was from a cold run and the latest is from it heat soaking for about an hour or so.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}