![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
updating from v1.2.4-1 to ratos 2.0
hi im planning on updating to ratos 2.0. i got some questions. after i flash the sd card. can i just plug in the sd card to the pi and continue, or do i have to disconnect all wires on the btt?
in the guide it says "It is heavily recommended that you flash your board and make sure it is detected in the configurator before you plug in your stepper drivers and start connecting your wiring."
and also, do i have to do anything after all is done? ive saved my printer.cfg, can i just paste it in and go? and a while back i saw someting that the bed_mesh is not going to work. i have not updated klipper after i got that message, but im planning on doing it after i get ratos 2.0 going. what do i need to do with that?
in the guide it says "It is heavily recommended that you flash your board and make sure it is detected in the configurator before you plug in your stepper drivers and start connecting your wiring."
and also, do i have to do anything after all is done? ive saved my printer.cfg, can i just paste it in and go? and a while back i saw someting that the bed_mesh is not going to work. i have not updated klipper after i got that message, but im planning on doing it after i get ratos 2.0 going. what do i need to do with that?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}