RRC[

Rat Rig Community [Unofficial]•3y ago•

2 replies

correct-teal

Bed Mesh Not Loading

IRatrig VMinion - 8 months old
Not loading bed mesh after updating klipper resulting in no print adhesion in one corner, to close in the other. It appears that the bed mesh is simply not being used - checked for movement on Z axis - nothing.

Action 1 - printer.cfg file checked - No change
Action 2 - bed manually leveled over many hours - No change
Action 3 - new probe installed - No change
Action 4 - fresh install of Ratos 1 , superslicer set to defaults - No change
Action 5 - email to Ratrig requesting support - no answer
Action 6 - fresh install of Ratos2, superslicer - all set to default - No Change
Action 7 - email to Ratrig asking for support - no answer yet.

I've seen so many people post this problem, I've not found a definitive solution yet(except tape underneath the bed).

If anyone can help I would really appreciate it as before all this, the machine was brilliant.

Thank you in advance.