![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Weird BLTouch Behavior
Hey y'all. After many successful prints with the BLTouch, all the sudden I am getting some really strange behavior out of it. When the printer turns on it will eject and retract the BLTouch as normal, but when I start a print or home the printer I run into the issue that the pin does not eject and wind up with a "BLTouch failed to verify sensor state" error. The sensor is not flashing but wont respond to a BLTOUCH_DEBUG COMMAND=pin_down either. Manually pulling the pin out doesnt result in a sensor state switch from open to closed. I have tried moving the sensor pin and ground (PB7 on my octopus board) over to the other PB7 pin for an inductive sensor, and I even tried moving it to a stop switch sensor (PG10 on my octopus board) and updated the printer.cfg accordingly to no avail.
It is as if klipper seemingly forgot how to operate a BLTouch. Any help would be appreciated.
It is as if klipper seemingly forgot how to operate a BLTouch. Any help would be appreciated.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}