RRC
Rat Rig Community [Unofficial]•13mo ago
like-gold

BTT Smart Filament Sensor Issue

Can’t figure out why my sensor isnt working? I added a sensor to PG10 on my octopus pro board. And also added the configuration for the sensor (as seen in photo). I added the # on the lines to temporarily fix the issue. The error is that my printer wont print and would have the issue ‘The value ‘my_sensor’ is not valid for SENSOR’ Please also see the photos for the location of the sensor
No description
No description
4 Replies
Helge Keck
Helge Keck•13mo ago
dont connect it to the endstop connectors use a free pin from the expansion slot
like-gold
like-gold•13mo ago
Got it! Will check it out
lostpex
lostpex•12mo ago
BTT Smart Filament Sensor
ptegler
ptegler•12mo ago
...know I saw it somewhere...BTT states a specific port...thought it was the last (stop_7 on the Octopus pro 1.0) end stop only for proper ops...can't find the message now though 🤨
Want results from more Discord servers?
Add your server
More Posts
Rear z-axis motor not running smoothlySo I finally got round to building my v-core 3 500, got the bltouch setup and ran my first home whicKlipper reports: ERROR Duplicate Chip name 'probe'I am working on installing RatOS on a new vminion that has a BTT SKR2 controller and Rasp Pi Model 3TMC 5160 pro for stepper X and Y ProblemsHi, i have installed two TMC 5160 pro for stepper X and Y, i have changed how is told in here https:Making max_accel_to_decel proportional ?I can't get max_accel_to_decel to adjust dynamically on Accel changes and couldn't find answers in pResHelper on RatOs?I'm still getting ringing on my printer even after an input shaper tune, and it was suggested I tuneCannot obtain IP address over EthernetI cannot obtain a normal IP address when connecting over Ethernet. It always gets the address 169.25dimples and first layer issuesHey, using thr v-minion which is a great little printer for enclosure required plastic. I get dimpleUnderextrusion New PrinterI have a 500 with orbiter V2, mosquito magnum. I followed the guide for the firmware configurations Webcam not found after Update to Crowsnest v4After Update of my 3.1 to Crowsnest V4 my Raspi-Cam (CSI) is not working any more. The crowsnest.loAdaptive meshHi I have been trying the baked in adaptive mesh and i have added the variable_adaptive_mesh line an