Crowsnest - Webcams wont show work.
Hello, I have tryed for hours now and i cant get my cameras to work. I have updated to V4.
My log:
PollePro•345d ago
Found my problem, I had to change to /webrtc and change my nozzle cam to /webcam2/webrtc also service to WebRTC, Both working now 🙂
PollePro•345d ago
miklschmidt•345d ago
you prolly want to change snapshot to /webcam2/?action=snapshot as well 🙂
PollePro•345d ago
ahhh yes good point 😄
Want results from more Discord servers?
More PostsDramatic later shift every layerI have a Vcore 500mm, and I'm experiencing these layer shifts at 15k accel. The grub screws are tighFresh RatOS install Crowsnest brokenJust a heads up, I had to do a manual "git pull" in ssh to update crowsnest when doing a fresh instPoor Bed adhesionHaving trouble with bed adhesion (again). Can't get ASA to stick to it, I have to wash it with soapyMesh levelling stopping about halfway through G29My BLTouch seems to be working, homes fine, but it can't complete a G29 mesh. It stops with the warnIssues w. extruder stepper (LDO-36STH20-1004AHG from lgx lite) since upgrade from RO2.0.0 to v2.0.1my stepper doesn´t work since the upgrade and reflashing the sd card. The stepper doesn´t react, no Strange Bed Level Test ResultHow can I fix this?belt shiftingOk..I have a odd issue that doesn't make any sense. I did a print almost 2 weeks ago and shut the prdouble peaks on YHi, did someone have such graph? Did you managed to fix it? Any ideas why is it so?Part Cooling Fan dauerhaft aktivSeit neuestem ist bei meinem Minion der Lüfter für die Bauteil Kühlung dauerhaft aktiv. Ich konnte lCan't equalize belt tensionI have such graph currently, if I try to tighten lower belt, my gantry moves out of square(when I mo