![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Parallellogram prints
I posted a while ago about suspecting the printer wasnt all square, and I just can seem to figure out what to do. I just removed the left and right motors to check the x-y gantry squareness, and its as square as can be measured with my engineering square. I loosened the belts and tightened them equally. re-did the alignment of the y-rails, and X-gantry alignment again. After firing up the printer again its still slightly off. The calibration cube comes out as a parallellogram. How do i proceed to fix?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}