![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
extruder below min temp + Error evaluating "gcode_macro _Park :gcode' : Undefinederror: 'dict objec'
Greetings legends,
Recently I started getting errors such as "extruder below minimum temp". Usually towards the end of the print.
I ran a few PID tuning, still had the same issue. The thermistor and heater cartridge seemed fine, however I replaced the dragon HF with a brand new Rapido.
Ran PID, checked printer.cfg if the new values were in place, sadly same thing happened again.
I'm starting to think that something is wrong with the board. Anyone got suggestionis?
Currently my vc3 has 60% fail rate
Recently I started getting errors such as "extruder below minimum temp". Usually towards the end of the print.
I ran a few PID tuning, still had the same issue. The thermistor and heater cartridge seemed fine, however I replaced the dragon HF with a brand new Rapido.
Ran PID, checked printer.cfg if the new values were in place, sadly same thing happened again.
I'm starting to think that something is wrong with the board. Anyone got suggestionis?
Currently my vc3 has 60% fail rate
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}