Octopus Max EZ with Klicky

I have a Klicky that states its expected state is deployed but it is stowed. When it is actually deplaoyed. Probe was working on a Octopus v1.1. All I did was move it to the new board. I have tried all 4 below with no success. I am connected to the PF11 and GND. Thanks.

Klicky probe (please read the RatOS documentation for instructions)

[include RatOS/z-probe/klicky.cfg]
#[include RatOS/z-probe/unklicky.cfg]

Inductive probe configuration

[probe]
z_offset: 0.0 # Adjust this to fit your setup
pin: ^probe_pin # For NPN NC probes such as the Super Pinda / Vinda / SupCR / Decoprobe probes.
#pin: ^!probe_pin # NPN NO (refer to the specs on your probe)
#pin: probe_pin # PNP NO (refer to the specs on your probe)
#pin: !probe_pin # PNP NC (refer to the specs on your probe)