VCore 3.1 enclosed mesh
Having a lot of trouble getting my mesh better. I've run out of room to adjust due to the enclosure panels not having anymore room for the bracket to go up. Anyone have any ideas of what else I can try to fix this?
3 Replies
I was running into a similar dilemma, I was thinking about removing the panel on the problem side, adjusting then putting the panel back on. It would be a lot of work, so maybe someone else has had luck with a similar problem
genetic-orange•15mo ago
I had tried this but sadly there's only a certain amount of wiggle room before the panel doesn't fit
genetic-orange•14mo ago
Same for me. Have not found a solution, unfortunately