RS
harsh-harlequin
when water is below its freezing point but doesn’t freeze due to lack of nucleation sites
when water is below its freezing point but doesn’t freeze due to lack of nucleation sites
16 Replies
harsh-harlequinOP•2y ago
but if it’s disturbed enough or if a nucleation site is introduced, it will start to freeze
must be a bug then
harsh-harlequinOP•2y ago
there are some differences due to the real world being made of atoms and not programmed pixels, but the behavior is still surprisingly similar
like how in sb it happens because of state checks not being done, but irl it happens because of lack of nucleation sites
but the end result is still similar; both can be said to change state when disturbed by another object
wise-white•2y ago
i got something slightly similair (idk how to crop the image)
harsh-harlequinOP•2y ago
save with 9995°C water from incinierate trick
dependent-tan•2y ago
yeah
harsh-harlequinOP•2y ago
it should drop to the floor as a liquid
dependent-tan•2y ago
you replicated it
harsh-harlequinOP•2y ago
but if you put sand or something in it then it should immediately boil
yelping-magenta•2y ago
wait how did yall do this
harsh-harlequinOP•2y ago
step 1. put ice down
step 2. use the incinierate tool on it for 1 tick
step 3. the state change code will only be run once in that tick, so it will change from ice to water, but not subsequently change from water to steam
the end result is liquid water at 9,995°C
wise-white•2y ago
do i gotta do it in 1tps
yelping-magenta•2y ago
ohhh i finally understand it now
my stupid brain was trying to place water down and incinerating it
if pixels r the same temperature they dont transfer heat and so no state change check happens
so... hyperheated water
rare-sapphire•2y ago
made a playground to mess around with a buncha different things at once
