RRC
Rat Rig Community [Unofficial]•7mo ago
broad-brown

update failed - I holds on initializing

I get yesterday my new (used) Minion. It runs in my network until I made all the suggested Updates. What can I do?
3 Replies
MONSOONO
MONSOONO•7mo ago
Can you provide more information about error messages, expected vs observed behaviour?
miklschmidt
miklschmidt•7mo ago
ctrl + shift + r to bypass browser caching. If that doesn't work, try using the IP instead of ratos.local (find the IP in the admin interface for your router).
broad-brown
broad-brown•7mo ago
Many thanks. In the meantime, I have reinstalled RatOS. It was easier than I had feared. However, this was not done with the BalenaEtcher, but with the Pi Imager.
Want results from more Discord servers?
Add your server
More Posts
Octopus Max EZ 2 Controller FansHow would I map in 2 x 2 Pin controller fans? At some point these will get switched over to 2 x 4 HelpLost with this one. I noticed that the diagram said check the wiring. So I have two micro switches aDid I nail it?I have no idea what I'm looking at in these charts but I think ZV is what I want. Is this good or isZ-Tilt Issues Octopus Max EZ on EZ5160 Pro running 48vEverything homes fine X, Y, Z however Z-Tilt the X,Y steppers are fighting each other always in the Web cam brokenBeen away from RatOS for a while. Updated everything and noticed that the web cam is blank. Have a LMoving servo shuts down octopus 1.1 boardHi. I have been running this for more than six months: RPi 3a+ powered from GPIO and servo for klickRetraction settings 0.6 nozzle cant seem to get it rightive tuned pressure advance and now im struggling with retraction settings. when i used 0.4 nozzle itV-minion X motor cranking/skippingHey guys, suddenly X motor started to stop, crank and skip. Time for a new stepper?