RRC
Rat Rig Community [Unofficial]•6mo ago
mere-teal

Endstops constantly triggered

Hello! I'm trying to configure my vcore 3.1 Went through the installation of ratOS, all going well, steppers fine, movement okay, next step was checking endstops. And my y, z and probe are constantly triggered. X endstop is working fine. Any idea why? Any and all help appreciated, TIA
2 Replies
blacksmithforlife
blacksmithforlife•6mo ago
without more detail, probably wiring issue
mere-teal
mere-teal•6mo ago
I can provide details, only I didn't know what. Please ask me... I still haven't been able to troubleshoot this.
Want results from more Discord servers?
Add your server
More Posts
Manual Input Shaper Calibration Print ProblemsI am following the tuning guide from RatOS documentation to calibrate a V-core 3.1 400mm printer. Uadaptive Mesh generating "move out of bounds" error when parts are close to the edge of the bed.In ratos 2.0 with adaptive Mesh enabled. If I put a part close to the edge of the bed. I get a move Loud rail soundsI recently installed the toro tube and regreased my rail,their smooth,but as soon as i install the xcalibration confusionWell i try to make a cable Container with some rotating parts but i have some issues that the parts Input Shaper is on, but still getting ghostingV-core 3.1 500. I have done SHAPER_CALIBRATE and input shaper is in the printer cfg, but still gettABS bed adhesion issuesDoes anybody have an idea, why I have these intermittent adhesion problems with my print sheet? The