Caps lock led indicator on hiney 87nu
Any guides or qmk file about this topic? I want to install a led indicator but i don't know what i am supposed to do in qmk or via to enable this function in this pcb
7 Replies
Do you mean 87nu? If so check the back of the PCB by caps lock. Solder in the led light on the caps lock key. There are three labeled pads. You need to put a blob of solder between center pad and I forgot if it was the left or right pad, but should it be labeled. That's it and it requires no programming.
yep, idk why that is not working for me, the thing is if i allow RGB underglow on via and try the led in other position the led works... so im lost
The other position is to enable backlight mode so that part is normal.
Have you tried flashing the stock firmware yet? Also take a pic of the backside of the PCB by the capslock key.
Ye but i don`t reach any solution, scroll lock works fine (the light is less bright but at least work) but for some reason caps lock doesn't
Solder the LED in the correct orientation and connect the marked areas on the back of the board and it should work.
Thanks to both of you :), there must be a bad joint between the pads, I desoldered everything, put new solder and now it works perfectly