Printer stops while priming nozzle
Hey,
for some reason my VCore 3 300mm stops while doing the prime blob. It stops the second that the bed is supposed to go down and the printhead backwards. I havent changed the hardware or setup of the printer. It just stopped working a few days ago. The only thing that changed, is that i have a new pc, and a factory reset slicer. For the slicer setup I have copied the start gcode from the RatOS Setup page into orca slicer. But I dont think the gcode is the issue, since the identical gcode that has worked before, dosent work now. I am really confused and frustrated, and would be happy to get some help :/
1 Reply
btw: The console dosent print out anything
Update: There wasnt a sd card in the octopus, and after putting one in it works. Idk if this really solved the issue or if it was some other software wizardry. But it works. And im happy now. Other than the fact, that my bed is higher on one side that the other.