Hi, I'm bulding joistick - not ruder so
Hi, I'm bulding joistick - not ruder so I need two X and Y. I've tried to disable offline motor. After that configurator can read data from online motor.
Additionally I've checked:
- motor data cable is ok (both pairs)
- mainboard is ok (working motor is identifiable on any data port)
- Motor X is offline in any combination but it is blinking the same as other motor when not connected (motherboard is always quiet)
What to do?
Is motor Id could be updated somehow?
8 Replies
Can you take a picture of both motors?
yep, sec
can you describe the blinking pattern of both motors?
X should go like this: -------------- blink --- blink ---------
Y should go: ------------------- blink ---------------
Bottom one is X
Just in case you didn't notice, I've DM'd you