Odd Z error
I have had this odd error. Can anyone tell me what i need to do to fix it?
12 Replies
Hello,
It sounds like your probe catch the bed before klipper tells him to move up to detect it. Maybe Manually push it down a bit and see what happens ?
When i loft the bed up to trigger it the light does go out. Nothing happens on the Console though
Thus thing is a huge paperweight until i can figure this out.
have you verified the correct behavior in the machine tab of mainsail? I don't have mine open right now, but there should be a button in there to see what the status of the probe is. You have to click the button to get the status. So move all metal away from the probe, then click the button -> it should read as open. Move metal close to probe, then click the button -> it should read as closed.
When i do an X Y Z homing it works fine but when i click z-tilt that is when the error appears.
can you show a picture of the bed from the front of your machine? Also upload your printer.cfg
I ordered two new probes.
can you upload your printer.cfg?