X Endstop Always Triggered

I'm having an issue where my x endstop is always showing as triggered in Klipper. The endstop light turns on when pressed, but seems not to register the input.
I'm following this ↓ wiring diagram for the octopus.
I've replaced the wire because I thought the the other one was getting hot - and, because I had to flip the wire. With the new wire (pictured) I still can't get it to work, so I can't tell if it's a hardware or software issue.
Thanks for any input, I really appreciate it.

Mmatt707_I'm having an issue where my x endstop is always showing as triggered in Klipper...

Max•3/22/24, 9:37 PM

Are you able to share your printer.cfg file? Also it seems like either the black cable is not crimped correctly, or the connector isn´t correctly seated in the casing. You should not be able to see bare wire here:

Max•3/22/24, 9:40 PM

The crimp connection should look like this, where the rear part of the crimp connector is clamping onto the wire insulation. Have a look at this guide for more information: https://www.instructables.com/Make-a-Good-Dupont-Pin-Crimp-EVERY-TIME/

Instructables

Make a Good Dupont Pin-Crimp EVERY TIME!

Make a Good Dupont Pin-Crimp EVERY TIME!: Anyone working with an Arduino, Raspberry PI, Beagle Bone, or any other multi-circuit-board project has become familiar with .025 X .025 in, square post pins and their mating connectors. The male pins are usually mounted to the circuit board with bo…

matt707_OP•3/24/24, 7:43 PM

Thanks Max that’s super helpful info. I was able to get it working!

X Endstop Always Triggered

Similar Threads

Similar Threads

Similar Threads