RRC
Rat Rig Community [Unofficial]•3mo ago
more_problems

How to multi_pin [controller_fan controller_fan]?

Hi, I have two fans cooling my drivers on the octopus. I can't find a way to assign them both to [controller_fan controller_fan] as defined in v-core-3.cfg. I can still define a custom fan with pin=multi_pin:name of choice and it works, but not with controller_fan.
No description
No description
3 Replies
blacksmithforlife
blacksmithforlife•3mo ago
Easier to just create another controller fan for the second pin
more_problems
more_problems•3mo ago
Ok, I'll forget this. Thank you.
blacksmithforlife
blacksmithforlife•3mo ago
Want results from more Discord servers?
Add your server
More Posts
Board not connecting to my pi.I attempted to reconfigure my printer after hardware changes. However, the board doesn't automaticalStepper Übertemperatur nach 4028 tauschHallo in die Runde, ich habe heute meinen 4028 gegen was brauchbares getauscht und wie es halt immerOvertemp Error after changing 4028 fanHello everyone, today I swapped my 4028 for something useful and as it always goes, the next part glBacklash by Bondtech LGX-LiteI'm making this post because maybe somebody will make the same mistake I did. I upgraded my LGX-LiteCant find the issue between 75 and 140 HZIve an Ratrig VCore 3.1 400 enclosed with the new toolhead and i cant find the reason why i have thatrying to print the fan duct in ASABut it's coming out pretty poorly. What could be causing these issues?huge cliff on meshV-Core 3.1 500 - the low X high Y corner - or back left of the printer falls off ~1/2mm. I tried addVcore 3.1 400mm, does this look right?Im trying to understand the resonance graphs but its going over my head just a little bit. Does tpi 5 Ratos support or workaroundAnyone know how to get ratos to work with the pi 5?Wavy meshV-core 3.1 500 i am very confused by the wavy mesh i get, could someone plekase elaborate what is ha