![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
TMC Overheat on vcore 400, octopus-11, cooled TMC 2209 and amps 1.1.
I have 1 year old vcore 400. It has cooled mbo with 120 mm fan and cooled xy-motors. I added cpap-cooling about 2 weeks ago and its fine. Printer is in my work room so I added xy-decoupling mod to it yesterday for lowering sound volume. After install printer started to throw tmc-overheat errors. Lowered amps to 1.1 from 1.6 and I still get tmc-overheat error. I have swapped the driver but I still get overheat-error.
As far as I understand there is pretty much 3 possibilities: Motor failing, Cable failing or Octopus failing. Any other good suggestions?
Cable was just taken off from motor for installation and put back. I am pretty much 100% sure that it is not the cause of this problem. But I will of course swap cable if no other cause is found.
Is there a possibility that decoupling mod somehow bends the axel of the motor or send some vibrations to motor?
I attached logs from last print.
As far as I understand there is pretty much 3 possibilities: Motor failing, Cable failing or Octopus failing. Any other good suggestions?
Cable was just taken off from motor for installation and put back. I am pretty much 100% sure that it is not the cause of this problem. But I will of course swap cable if no other cause is found.
Is there a possibility that decoupling mod somehow bends the axel of the motor or send some vibrations to motor?
I attached logs from last print.
klippy_10.log2.34MB
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}