![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Bad quality print
This is my first print on my new V-core 3.1 500³. The gyroid infill is really bad & caused the top layer to not have enough to stick to leaving holes in the top layer. The bottom & walls look fine with just a little retraction to be tuned in.
I sliced in OrcaSlicer with 200mm/s inner, outer & infill with 100mm/s for top surface. 0.2 layer with 0.6mm for inner & outer wall & 0.4 everywhere else.
I am using RatRig green ABS 265°C with 95% flow ratio.
Any suggestions to fix this???
I sliced in OrcaSlicer with 200mm/s inner, outer & infill with 100mm/s for top surface. 0.2 layer with 0.6mm for inner & outer wall & 0.4 everywhere else.
I am using RatRig green ABS 265°C with 95% flow ratio.
Any suggestions to fix this???
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}