![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Orbiter v2.0 not extruding
Well as the title says, I just received my Orbiter 2.0 today and it's not extruding.
Just by running the printer it has a quiet but still hearable high pitch noise. Is this normal?
Wenn I heat up the hotend, and extruder X mm of filament, I can hear a change in sound, but the filament doesn't get pulled into the extruder.
Board used: BTT Octopus v1.1
I'm running following config:
Just by running the printer it has a quiet but still hearable high pitch noise. Is this normal?
Wenn I heat up the hotend, and extruder X mm of filament, I can hear a change in sound, but the filament doesn't get pulled into the extruder.
Board used: BTT Octopus v1.1
I'm running following config:
Solution
Nevermind, I'm probably one of the dumbest people on earth. The dir pin was inverted - therefore extrude was retract and retract was extrude
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=44){kind=icon}
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}