Everything under update manager showing up as invalid.

I have purchased multiple expensive SD cards, multiple Octopus boards and different Raspberry PIs. There is some bug that makes the blower fan blow at 100% speed and the motherboard connects for a second but then disconnects over and over again and it says klipper unable to connect. When the motherboard is off it says mcu unable to connect meaning this is only happening when the motherboard is on. Not sure what is going on but here is an image. I've also tried repeatedly flashing RatOS on multiple SD cards and starting from scratch but whenever I make some changes to the printer.cfg file this issue just happens again with the blower fan at 100%.

blacksmithforlife•6/13/24, 10:53 PM

Upload the printer.cfg that is causing the issue

ShadowZSniperOP•6/13/24, 11:02 PM

I just cleaned the SD card and went down from 2.0.2 to 2.0

ShadowZSniperOP•6/13/24, 11:02 PM

I will upload the printer.cfg if the issue still persists

ShadowZSniperOP•6/13/24, 11:02 PM

question

ShadowZSniperOP•6/13/24, 11:03 PM

by updating in the update manager, does my RatOS version automatically become the latest?

ShadowZSniperOP•6/13/24, 11:03 PM

or is there some things that cannot change unless I flash a newer pi image?

ShadowZSniperOP•6/13/24, 11:14 PM

ShadowZSniperOP•6/13/24, 11:14 PM

Getting this issue now

ShadowZSniperOP•6/13/24, 11:15 PM

message.txt13.91KB

ShadowZSniperOP•6/13/24, 11:35 PM

In RatOS configurator I've had this issue on multiple, pis, sd cards, octopuses

ShadowZSniperOP•6/13/24, 11:35 PM

where it detects the board but it says unresponsive

ShadowZSniperOP•6/13/24, 11:36 PM

it gives me the option to flash but the flashing doesn't go throuh

ShadowZSniperOP•6/13/24, 11:36 PM

through*

Everything under update manager showing up as invalid.

Similar Threads

Similar Threads

Similar Threads