MCU Protocol Error

Basically, I'm getting the following errors

guesswhatsthisparlorOP•7/24/24, 10:38 PM

MCU Protocol error

This is frequently caused by running an older version of the
firmware on the MCU(s). Fix by recompiling and flashing the
firmware.

Your Klipper version is: v0.12.0-261-g248d3dbf-dirty
MCU(s) which should be updated:
mcu: Current version v0.12.0-261-g248d3dbf
rpi: Current version ?-20240528_040405-fv-az891-544
toolboard_t0: Current version v0.12.0-261-g248d3dbf
beacon: Current version Beacon 1.1.0
Up-to-date MCU(s):
<none>

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.

Outdated Beacon firmware version 0.1.0, current version is 2.1.0.
Please run install.shinstall.sh or update_firmware.py update allupdate_firmware.py update all to update to the latest version.
Using an outdated firmware version can result in instability or failures.

mcu 'beacon': Unknown command: beacon_contact_home

guesswhatsthisparlorOP•7/24/24, 10:41 PM

config-20240725-003944.zip1.85KB

guesswhatsthisparlorOP•7/24/24, 10:43 PM

moonraker.log108.57KB

chicken•7/25/24, 4:49 AM

This ratos 2.1? Have you gone to the machine tab and upgraded everything?

TheTik•7/25/24, 12:51 PM

Have you tried following the instructions in the error message?

ADSRMedia•7/29/24, 2:13 AM

I'm having the exact same error installing 2.1. I did a clean install on my sdcard. I've tried updating the Octopus 1.1 via automatic and DFU in the setup and ended up with the same error. Re: following instructions....Are you referring to updating the firmware or was there something else? I'm not working on the beacon just yet because i thought updating the firmware was done via the plugin after I can get the MCU to boot properly. Any further thoughts?

TheTik•7/29/24, 2:24 AM

No, that sounds like you're on the right track

ADSRMedia•7/29/24, 2:36 AM

There was another thread about it where miklschmidt said to run this script on the pi: ~/printer_data/config/RatOS/scripts/ratos-update.sh~/printer_data/config/RatOS/scripts/ratos-update.sh I think I had to sudosudo it, but I got the MCU to boot after running the script and reboot. Thought I would add this here to see if it helped @guesswhatsthisparlor. The post thread I mentioned is here: ratos-supportRatOS/MCU/Klipper failure after update (Octopus Pro 446). Thanks everyone for all your help!