Shen - Hello,I've a nullbit tidbit with a "Ke...
Hello,
I've a nullbit tidbit with a "Key Micro” Atmega MCU.
I'm trying do install by RGB underglow, it's not a success ...
I've no led at all. I've tried to:
- "ping" grd on each led
- use this schematic and try each in/out
- double check "RGBLIGHT_ENABLE = yes" in rules.mk
- wired the first LED to B2 and change RGB_DI_PIN
Everything is "ok"
My guess was that the first one has an issue, I've replaced it just to be sure ... but I can "ping" correctly to the micro controller.
Do I need a resistor?
I don't have other idea right now
Thank you very much,
I've a nullbit tidbit with a "Key Micro” Atmega MCU.
I'm trying do install by RGB underglow, it's not a success ...
I've no led at all. I've tried to: - "ping" grd on each led
- use this schematic and try each in/out
- double check "RGBLIGHT_ENABLE = yes" in rules.mk
- wired the first LED to B2 and change RGB_DI_PIN
Everything is "ok"
My guess was that the first one has an issue, I've replaced it just to be sure ... but I can "ping" correctly to the micro controller.
Do I need a resistor?
I don't have other idea right now
Thank you very much,
