Legion Go Gyros not working
Hey 
Thank you for your amazing work. Today my Legion Go arrived and I installed bazzite-deck on it.
I'm on Bazzite 40, stable, Kernel 6.9.12-205, BIOS N3CN35WW, Steam Version 1726683985.
HHD is already preinstalled, version 3.3.15, GUI Version 3.2.1, TDP Adjustor version 3.4.7.
I'm using Dualsense Emulation and everything works, so touchpad, general controls and with Dualsense Edge Emulation even the back buttons are interpreted as dedicated buttons and it works.
Unfortunately gyros (& the "FPS mode" mouse sensor of the right controller) don't work at all, with either Dualsense emulation setting and regardless of when I choose Left, Right or Both Controllers and Gyros devices.
The Gyro Calibration Tab exists in Steam Game mode but it unfortunately just reads plain 0s in all axes, constantly. Even if I'm shaking them furiously. The controllers are detached then of course.
EDIT: I just also reset the controllers by both inserting a pin in the hole of the side for the controller (did just briefly turn off and on again) and by pressing & holding Legion L + LB + LS (did vibrate, fully turn off and change the RGB color to green). But after that and even reconnecting, still no change; gyros still show 0.
Thank you for your amazing work. Today my Legion Go arrived and I installed bazzite-deck on it.I'm on Bazzite 40, stable, Kernel 6.9.12-205, BIOS N3CN35WW, Steam Version 1726683985.
HHD is already preinstalled, version 3.3.15, GUI Version 3.2.1, TDP Adjustor version 3.4.7.
I'm using Dualsense Emulation and everything works, so touchpad, general controls and with Dualsense Edge Emulation even the back buttons are interpreted as dedicated buttons and it works.
Unfortunately gyros (& the "FPS mode" mouse sensor of the right controller) don't work at all, with either Dualsense emulation setting and regardless of when I choose Left, Right or Both Controllers and Gyros devices.
The Gyro Calibration Tab exists in Steam Game mode but it unfortunately just reads plain 0s in all axes, constantly. Even if I'm shaking them furiously. The controllers are detached then of course.
EDIT: I just also reset the controllers by both inserting a pin in the hole of the side for the controller (did just briefly turn off and on again) and by pressing & holding Legion L + LB + LS (did vibrate, fully turn off and change the RGB color to green). But after that and even reconnecting, still no change; gyros still show 0.
