![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Octopus V1.1 doesn't want to flash / get recognized by RatOS 2.1.X
Hi, earlier during my V-Core 4 build I accidentally installed RatOS 2.0.X. Now I reflashed the SD-Card with 2.1.X, and am trying to configure it. But for some reason no matter what I try, flashing the octopus doesn't seem to work in the configuration wizard.
Automatic flashing says there is no board detected.
In the DFU overview I can get it to detect it with the BIOS0 header, and then half a minute or so after pressing flash it simply shows the same, initial, DFU screen, as if it did nothing and can't detect it.
Pressing "Check Board Status" in the SD-Card section doesn't do anything, when in 2.0.X it did work for me.
Could this be related to all the wiring being connected to the Octopus already now? I did already compile the firmware and put it on the SD-Card of the Octopus.
When pressing the unidentified board option, it allows me to flash the board, but then I get the error shown in the image.
I tried updating all the dependencies, and eventually I manually forced the conf wizard to the 3rd step through the URL and finished setting the rest up succesfully (toolboard etc). But in the dashboard I still get the same error:
I actually am kind of at a loss at this point. Any help would be greatly appreciated, and I'll look at it again in a few hours. Thanks!
Automatic flashing says there is no board detected.
In the DFU overview I can get it to detect it with the BIOS0 header, and then half a minute or so after pressing flash it simply shows the same, initial, DFU screen, as if it did nothing and can't detect it.
Pressing "Check Board Status" in the SD-Card section doesn't do anything, when in 2.0.X it did work for me.
Could this be related to all the wiring being connected to the Octopus already now? I did already compile the firmware and put it on the SD-Card of the Octopus.
When pressing the unidentified board option, it allows me to flash the board, but then I get the error shown in the image.
I tried updating all the dependencies, and eventually I manually forced the conf wizard to the 3rd step through the URL and finished setting the rest up succesfully (toolboard etc). But in the dashboard I still get the same error:
I actually am kind of at a loss at this point. Any help would be greatly appreciated, and I'll look at it again in a few hours. Thanks!
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}