Clogging issues with Revo hotend

Small prints/parts are fine. But when i go into bigger more complex prints it clogs after some minutes. what ive tried: Ive lowered the volumetric rate in orca slicer to 14 no difference. ive replaced the fan first had a noctua fan. But went for a Winsin (https://www.amazon.nl/dp/B0757RPCN9?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) Im kinda stuck now and dont know what is next. Is this fan even good enough. Should I lower print temps. Because im pretty sure its heatcreep Btw i have the voron revo. Vcore 3.1 500mm lgx lite extruder (which gets really hot) Enclosure Beacon pobe
WINSINN 40mm Fan 24V Hydraulische Lager Borstelloze 4010 40x10mm - ...
► Hydraulische Lagers - Hoge snelheidsversie ► Hoog - kwaliteits Hydraulische lagers, Beter dan Olielagers, stabieler en Met lange levensuur, geschikt voor het ononderbroken werk. De levensverwachting is ongeveer 45.000 uur. ►Grootte: 40x40x10mm ►Nominale spanning: DC 24V ►Lijnlengte: ongeveer 3...
2 Replies
onlyJ35T3R
onlyJ35T3R4w ago
It's probably heat creep, Noctua fans are not recommend for hotend cooling, these winsinn probably also have to low cfm. Had the same issue years ago. I can send you later a photo from a good Sunon fan with enough power to fix heat creep issues How many amps do you run on your lgx lite?
onlyJ35T3R
onlyJ35T3R4w ago
No description
Want results from more Discord servers?
Add your server