![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
weird new 'move out of range' after last update.....
heavily mod'ed 3.1 VC500 here... getting a negative Y value in a move out of range..
home all -> z_tilt -> warm up -> bed mesh -> then move to center front while hot end heats, then the very next move errors/freezes the machine with the statement
see pics here (under thumbnail in screen capture)
mesh is 100/100 400/400 so its not Euclid probe offset numbers vs mesh limts at the edge of the bed.
I can't figure out whe the heck the -13 is coming from! multiple g-codes same issue.
log files, printer.cfg, see all attached HELP!!!!!!
home all -> z_tilt -> warm up -> bed mesh -> then move to center front while hot end heats, then the very next move errors/freezes the machine with the statement
see pics here (under thumbnail in screen capture)
mesh is 100/100 400/400 so its not Euclid probe offset numbers vs mesh limts at the edge of the bed.
I can't figure out whe the heck the -13 is coming from! multiple g-codes same issue.
log files, printer.cfg, see all attached HELP!!!!!!
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}