Vcore 3.1 idex overhangs and support material
I'm using pla and polysupport pla on overhangs. Wondering if anyone can help me with my settings to improve this
1 Reply
Since this is a designated support filament you can probably get away with decreasing your support z-distance and increasing the support density. These are usually set as a compromise between providing adequate support and being able to remove the support from the print again.
Also if you can get away with it I would suggest a design without rounded overhangs, as those are never easy to print and you will probably spend a lot of time tuning them. Otherwise if you only care about the surface finish on the outside it may be an idea to turn the part upside down for printing so that the overhangs and supports are on the inside surfaces of the part.