![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Octopus v1.1 allows flashing to start, but reverts back to "Waiting For DFU..."
I am following the electronics setup for a v-core 4 IDEX. I am at the step where I need to flash the Octopus before proceeding. It appears to allow me to start flashing the board, but then drops back to "Waiting For DFU". Specific steps below.
1. Pi powered by wall USB adapter.
2. USB cable from Pi to Octopus (tried every USB port)
3. Board powered on with jumper in place, reset button pressed
4. RatOS shows the option to Flash to board.
5. Remove boot jumper
6. Press flash button. Changes to "Flashing..."
7. After a few seconds, button reverts to "Waiting For DFU..."
Any ideas on the next step to take here?
1. Pi powered by wall USB adapter.
2. USB cable from Pi to Octopus (tried every USB port)
3. Board powered on with jumper in place, reset button pressed
4. RatOS shows the option to Flash to board.
5. Remove boot jumper
6. Press flash button. Changes to "Flashing..."
7. After a few seconds, button reverts to "Waiting For DFU..."
Any ideas on the next step to take here?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}