![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z Probe issues
heya, so Im currently investigating weird behavior of my printer where seemingly out of nowhere i cannot home it.
Im using Pinda wired to the octopus 1.1 board and I checked the pins at the end of it to see if by any chance there wasnt any wire damage but no, signal at the end when not triggered and lack there of when triggered.
it happened after I adjusted the configurator so perhaps I wrote something wrong, the board doesnt respond to changing the state of the probe as if it was disconnected/defined incorrectly.
I'll appreciate any feedback.
Im using Pinda wired to the octopus 1.1 board and I checked the pins at the end of it to see if by any chance there wasnt any wire damage but no, signal at the end when not triggered and lack there of when triggered.
it happened after I adjusted the configurator so perhaps I wrote something wrong, the board doesnt respond to changing the state of the probe as if it was disconnected/defined incorrectly.
I'll appreciate any feedback.
RatOS.cfg14.32KB
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}