![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
V4 idex z offset issue
Hello,
I need some advise. Im getting terrible z offset cal, between 0.17 and 0.175. I have checked everything and disassembled both heads, twice. Also swapped nozzle, because why not.
I havent done what ratrig suggested, to use a shim as a last resort. But as far as i understand, this is only important if i use copy/mirror mode correct? For dual filament its ok? I dont think ill ever use copy/mirror mode. Should i bother to make it close to 0 as possible? What are the downsides of using a shim as a spacer?
I need some advise. Im getting terrible z offset cal, between 0.17 and 0.175. I have checked everything and disassembled both heads, twice. Also swapped nozzle, because why not.
I havent done what ratrig suggested, to use a shim as a last resort. But as far as i understand, this is only important if i use copy/mirror mode correct? For dual filament its ok? I dont think ill ever use copy/mirror mode. Should i bother to make it close to 0 as possible? What are the downsides of using a shim as a spacer?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}