RRC[

Rat Rig Community [Unofficial]•15mo ago•

2 replies

iKuro

Please help with Benchy Hull Line

I've started fighting with the abovementioned benchy hull line - I need to print a table leg extenders and started encountering this issue exactly at the point where the layer time changes.
Exactly in the point where the layer time changes as is shown in the picture.

General data for the print:
V-Core 3.1 300 with custom enclosure, Toolhead V1.
Fiberlogy ABS+
Print speeds:
400mm/s overall 6600mm/s^2 Accel's
Printing with Outer-Inner-Outer
Orca slicer 2.3 (beta) but same in 2.2 (Stable)

The print quality is great (maybe the input shaper needs a bit more adjustments but for me it's ok) except for this point. I've no good idea on how to solve it unfortunately...

In attachement My G-Code

What I've Tried so far:
Lowered Speeds (no influence within "reasonable" values - tested both on 200mm/s and 300mm/s.)
Lowered Accels (I printed usually with 15000mm/s^2)
Adjusted the print for layer time etc - still the line persists due to sudden change in the layer time/pressure.

Noga_v10_0.2mm_ABS_6h3m.gcode21.67MB