Changed stepper_x setting, now ratos error

I made a change in my printer.cfg to adjust my position_endstop and now I'm getting an ERROR about

allow_unknown_gcode_generator

allow_unknown_gcode_generator

, a value i never touched

Ran a few updates this morning and didnt run into this issue until now

Option 'allow_unknown_gcode_generator' is not valid in section 'ratos'

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted

Option 'allow_unknown_gcode_generator' is not valid in section 'ratos'

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted

Solution

Jump to solution

RRC[

Rat Rig Community [Unofficial]•15mo ago•

19 replies

Decker

Changed stepper_x setting, now ratos error

I made a change in my printer.cfg to adjust my position_endstop and now I'm getting an ERROR about

allow_unknown_gcode_generator

allow_unknown_gcode_generator

, a value i never touched

Ran a few updates this morning and didnt run into this issue until now

Option 'allow_unknown_gcode_generator' is not valid in section 'ratos'

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted

Option 'allow_unknown_gcode_generator' is not valid in section 'ratos'

Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted

Solution

Jump to solution

Continue the conversation

Join the Discord to ask follow-up questions and connect with the community

RRC[

Rat Rig Community [Unofficial]

The #1 unofficial Rat Rig Community on Discord!

14,034 Members

Join

Changed stepper_x setting, now ratos error

Changed stepper_x setting, now ratos error

Continue the conversation

Rat Rig Community [Unofficial]

Continue the conversation

Rat Rig Community [Unofficial]

Similar Threads