Lag when typing
I am having lag on both sides when typing. This is my second Typeractive Corne, so I flashed the same firmware as my first board that works fine. My setup is the same with both boards, like same distance from computer, same mouse, etc. The only difference is the first board is soldered, the second board is no solder. The board works, it's just lags to the point where I'm mistyping and changing BT profiles because my fingers are moving and the board is lagging behind.
I have tried:
1. Clearing BT
2. Reflashing stock firmware
3. Making a new repository and keymap
4. Flashing back to firmware from board one
Thanks!
4 Replies
It sounds like you've tried a lot of troubleshooting already! Let's see if we can get this figured out.
Since your first board works fine, we can rule out most environmental issues. The no-solder headers could be the culprit.
Try these steps:
1. Ensure the no-solder headers are fully seated in the PCB. The plastic should be flush with the PCB.
2. Make sure the nice!nano is firmly pressed into the headers.
3. Check the battery connection. Make sure the JST connector is fully plugged in.
If the issue persists, try enabling increased transmit power and disabling 2M PHY in your ZMK config. See our Poor Range guide for details.
If none of this helps, please reply to this message or tag me for further assistance.
Poor Range | Typeractive.xyz Documentation
Solve poor wireless range with your ZMK keyboard.
Everthing is flush, batteries are good, and I disabled 2M PHY. Still lagging.
not that it'd necessarily help, however is the left side laggy if it's plugged in and the right side left wireless/alone?
(I was playing with my setup lately to see how i could induce (or remove) lag and had the left cabled in while i progressively tried to degrade the right side)
Hmm do you only have trouble to this computer?