Anaconda Installer not Showing the GUI
So I'm trying to install Bazzite off the first time, I am installing via a M.2.NVMe Drive Connected via a USB 3.0 Adapter Caddy, the M.2 NVMe SSD has Ventoy installed on it and other Linux Distribution Installers + Windows 10/11 Installers Boot fine with no major graphical issues.
Initially the screens turn a "Off White" colour, not quite Grey, but not pure White either, it the screens flash, they show the same white colour again, they flash, they are now completely black as if they have no signal, they flash again, now they are off white, but one Screen is showing the Anaconda Installer where it let's you choose the Language at what I assume must be the start of the installation process as is the case with other Linux Distro using Anaconda for the installer.
Now suddenly the screen flashes again to black then I get display this time and can move the cursor across the display output, but, nothing else is visible, only the cursor.
I press CTRL + ALT + F1-F12 and cycle through the TTY Sessions, under TTY1 is terminal that says it is Anaconda in the bottom left hand corner with a green bar across the screen with other text saying things like "2: Shell" & "3: Log", etc.
I go to TTY6 via CTRL + ALT + F6, and in their is where it loads the active desktop session with the visible cursor but black screens, NOTHING else.
Under CTRL + ALT + F2 it loads TTY2 and says that it is running Fedora Linux 41 (Kinoite) + the Linux Kernel Version + Architecture Type (tty2)
Further down it starts the Terminal Entry with [anaconda root@fedora /]#
I try a few commands like "ls" or "startplasma" but it is no good, it doesn't run the command.
Initially the screens turn a "Off White" colour, not quite Grey, but not pure White either, it the screens flash, they show the same white colour again, they flash, they are now completely black as if they have no signal, they flash again, now they are off white, but one Screen is showing the Anaconda Installer where it let's you choose the Language at what I assume must be the start of the installation process as is the case with other Linux Distro using Anaconda for the installer.
Now suddenly the screen flashes again to black then I get display this time and can move the cursor across the display output, but, nothing else is visible, only the cursor.
I press CTRL + ALT + F1-F12 and cycle through the TTY Sessions, under TTY1 is terminal that says it is Anaconda in the bottom left hand corner with a green bar across the screen with other text saying things like "2: Shell" & "3: Log", etc.
I go to TTY6 via CTRL + ALT + F6, and in their is where it loads the active desktop session with the visible cursor but black screens, NOTHING else.
Under CTRL + ALT + F2 it loads TTY2 and says that it is running Fedora Linux 41 (Kinoite) + the Linux Kernel Version + Architecture Type (tty2)
Further down it starts the Terminal Entry with [anaconda root@fedora /]#
I try a few commands like "ls" or "startplasma" but it is no good, it doesn't run the command.
