![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Changes to Start_Print and End_Print
Hi, I would like to know what and how to make changes to G-code or printer config in order to accomplish a few things:
1) In End Print: keep bed heater on x amount of minutes after the print is finished. I often will start a print after one ends and have to reset the bed temp to make sure it's not losing heat before the next print.
2) In Start Print: Do not turn the hot end down to 150C prior to print if it is already at a higher temp (i.e. from a filament change between prints).
Here is what I have in my slicer (as per the RR instructions when I first configured the printer):
START_PRINT EXTRUDER_TEMP=[nozzle_temperature_initial_layer] BED_TEMP=[bed_temperature_initial_layer_single]
1) In End Print: keep bed heater on x amount of minutes after the print is finished. I often will start a print after one ends and have to reset the bed temp to make sure it's not losing heat before the next print.
2) In Start Print: Do not turn the hot end down to 150C prior to print if it is already at a higher temp (i.e. from a filament change between prints).
Here is what I have in my slicer (as per the RR instructions when I first configured the printer):
START_PRINT EXTRUDER_TEMP=[nozzle_temperature_initial_layer] BED_TEMP=[bed_temperature_initial_layer_single]
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}